Step-by-step walkthrough for fitting top track, bottom track, hanging doors, and roller wheel height adjustment.
Before you start
Check the floor is level. Use packers or a floor plate where needed; a floor plate is required over carpet. Check the tracks align vertically before drilling.
You will need:
Tape measure and pencil
Spirit level
Drill and suitable drill bits
#2 Phillips screwdriver
Suitable fixings for your walls and floor
Packers or a floor plate, if required
01
Fit the End Caps
Push the matching plastic caps into both ends of the top and bottom tracks.
02
Position Both Tracks
Position the top and bottom tracks, aligned vertically. Push the end caps outward to meet the jambs and cover the gaps, keeping them overlapping the tracks.
03
Secure Both Tracks
Secure at three fixing points along the bottom track, then three along the top track. Use fixings suited to your floor or floor plate and the timber frame above.
04
Fit the Doors
Fit the rear door first: tilt and lift the top into the rear channel, swing the bottom inward, then lower the wheels onto the matching groove. Repeat for the front door. Continue to the sliding and adjustment checks.
05
Adjust the Doors
Use a manual #2 Phillips screwdriver to adjust the bottom rollers until each door aligns with its matching jamb. Keep each door assigned to that side. Do not use a high-torque power drill on the adjustment screws.
06
Enjoy Your New Wardrobe Sliding Doors
Check that each door slides smoothly, aligns with its matching jamb and stays correctly seated in the tracks. Complete the installation and adjustment checks before use.
IMPORTANT: If your jambs are not plumb, the floor or top jamb is not level, or the opening is out of square, a door may sit flush against one side but leave a gap when moved to the other side. Adjust each door to its matching jamb, as shown in Step 5, and keep it assigned to that side.
Need installation? Reach out to us and we'll point you in the right direction.
